Customizing The Zone Member Display; Enabling Or Disabling The Default Zone For Fabrics - Brocade Communications Systems Brocade 8/12c User Manual

19
Zoning configuration

Customizing the zone member display

The following procedure applies to the zone display in the standard Zoning dialog box and also to
the LSAN Zoning dialog box.
1. Select Configure > Zoning > Fabric.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select an FC fabric from the Zoning Scope list.
4. Click the plus sign (+) by the appropriate zone in the Zones list to expand the listing and show
5. Right-click the name of any zone member and select Member Display.
6. Select or clear the check boxes for the properties you want to display or hide.
7.
8. Click OK.

Enabling or disabling the default zone for fabrics

1. Select Configure > Zoning > Fabric.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select an FC fabric from the Zoning Scope list.
4. Select the zoning database you want from the Zone DB list.
5. Click Zoning Policies.
588
For LSAN zoning, select Configure > Zoning > LSAN Zoning (Device sharing).
The Zoning or LSAN Zoning dialog box displays, based on the Configure > Zoning menu
selection.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
the zone's members.
The Zone Member Display dialog box displays.
All of the options are selected by default. You cannot clear the WWN / Domain,Port Index
check box. It is always selected.
Select a property and click the Up or Down buttons to rearrange the order in which the
properties are displayed.
The display is changed for all zone members in the Zones list.
The Zoning dialog box displays.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
The Zoning Policies dialog box displays.
NOTE
The format and content of this dialog box vary slightly depending on Interop Mode, the target
selected in the Zoning Scope list, and whether safe zoning mode is enabled. If safe zoning
mode is enabled, the Default Zone button is disabled. If you want to enable the default zone,
you must disable the safe zoning mode.
Brocade Network Advisor SAN User Manual
53-1002167-01