Editing a LAG
Use the following procedure to change members and policies in a link aggregation group (LAG).
1. Select Configure > DCB from the menu bar.
2. Select the link aggregation group (LAG) from the Products/Ports table.
3. Click Edit.
4. Configure the following LAG parameters, as required:
Brocade Network Advisor SAN User Manual
53-1002167-01
The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and
functions.
The Edit LAG dialog box displays.
FIGURE 123
Edit LAG dialog box
NOTE
Ports with 802.1x authentication or ports that are L2/L3 mode enabled are not supported in a
LAG.
•
Status - Enabled or Disabled. You must enable the LAG to use the DCB functionality.
•
LAG ID - The LAG identifier, which is not an editable field.
•
Interface Mode - L2 or none. For external ports, the L3 interface mode displays, in addition
to None or L2. If you select L3 as the interface mode, the IP/Netmask field is enabled and
you can then assign the primary and secondary IP addresses.
•
A port must be in non-L2 Mode if you are adding the port as a member of a LAG.
•
You cannot change the Interface Mode from L2 to none if the LAG is assigned to a
VLAN.
14
Switch policies
349