Application Configuration Wizard Troubleshooting - Brocade Communications Systems Brocade 8/12c User Manual

26

Application Configuration Wizard troubleshooting

7.
8. Click Cancel on the IP Performance dialog box.
Application Configuration Wizard troubleshooting
The following section states a possible issue and the recommended solution for Management
application Configuration Wizard errors.
Problem Resolution
Unable to launch the The Windows Vista, Windows 7,or Windows 2008 R2 system enables the User Access Control (UAC) option by
Management application default. When the UAC option is enabled, the Configuration Wizard cannot launch. If the Configuration Wizard
Configuration Wizard on does not launch, use one of the following options to disable the UAC option:
a Windows Vista,
The following are the various ways we can disable UAC in vista:
Windows 7,or Windows
Disable using msconfig by completing the following steps.
2008 R2 system
1
2
3
4
5
6
7
NOTE: You can re-enable UAC using the above procedure and selecting the Enable UAC tool name in step 4.
Disable using regedit by completing the following steps.
NOTE: Before making changes to the registry, make sure you have a valid backup. In cases where you're
1
2
3
4
5
6
7
NOTE: You can re-enable UAC using the above procedure and changing the Value data field to 1 in step 5.
760
Field/Component Description
DELAY The average round trip time to send a packet of data and receive the
acknowledgement.
PMTU The largest packet size that can be transmitted over the end-to- end path without
fragmentation. This value is measured in bytes and includes the IP header and
(Path Maximum
payload. IP Performance tries the configured Fabric OS Jumbo MTU value (anything
Transmission Unit)
over 15000, then 1500, then 1260. The value displayed in the table is the largest
value that worked.
Click Close on the IP Performance Result dialog box.
Select Start > Run.
Type msconfig on the Run dialog box and click OK.
Click the Tools tab on the System Configuration Utility.
Scroll down to and select the Disable UAC tool name.
Click Launch.
A command window displays and runs the disable UAC command. When the command is complete, close
the window.
Close the System Configuration Utility.
Restart the computer to apply changes.
supposed to delete or modify keys or values from the registry it is possible to first export that key or
value(s) to a .REG file before performing the changes.
Select Start > Run.
Type regedit on the Run dialog box and click OK.
Navigate to the following registry key:
HKEY_LOCAL_MACHINE\Software\Microsoft\Windows\CurrentVersion\Policies\System
Right-click the EnableLUA value and select Modify.
Change the Value data field to 0 on the Edit DWORD Value dialog box and click OK.
Close the Registry Editor.
Restart the computer to apply changes.
Brocade Network Advisor SAN User Manual
53-1002167-01