Enabling Backup; Disabling Backup - Brocade Communications Systems Brocade 8/12c User Manual

6. Enter the time (using a 24-hour clock) you want the backup process to begin in the Next
7.
8. Browse to the hard drive and directory to which you want to back up your data.
9. Click Apply or OK.

Enabling backup

Backup is enabled by default. However, if it has been disabled, complete the following steps to
enable the function.
1. Click the SAN tab.
2. Select Server > Options.
3. Select Server Backup in the Category list.
4. Select the Enable Backup check box.
5. Click Apply or OK.

Disabling backup

Backup is enabled by default. If you want to stop the backup process, you need to disable backup.
To disable the backup function, complete the following steps.
1. Click the SAN tab.
2. Select Server > Options.
3. Select Server Backup in the Category list.
4. Clear the Enable Backup check box.
5. Click Apply or OK.
Brocade Network Advisor SAN User Manual
53-1002167-01
Backup Start Time Hours and Minutes fields.
Select an interval from the Backup Interval drop-down list to set how often backup occurs.
The application verifies that the backup device exists and that the server can write to it.
If the device does not exist or is not writable, an error message displays that states you have
entered an invalid device. Click OK to go back to the Options dialog box and fix the error.
Backup occurs, if needed, at the interval you specified.
The Options dialog box displays.
The Options dialog box displays.
13
Backup support
325