Brocade Communications Systems Brocade 8/12c User Manual page 602

18
Re-keying all disk LUNs manually
FIGURE 263
4. Click Yes.
5. Open the Encryption Target Disk LUNs dialog box to see LUNs being re-keyed and LUNs
6. Select a disk LUN device from the table, then click LUNs.
.
FIGURE 264
558
Warning message - Re-key all
Re-keying operations begin on up to 10 LUNs. If more than 10 LUNs are configured on the
switch, the remaining re-key operations are held in the pending state.
pending.
a. Select Configure > Encryption from the menu task bar.
The Encryption Center dialog box displays
b. Select the encryption switch from the Encryption Center Devices table, then select Targets
from the menu task bar, or right-click the switch and select Targets.
The Encryption Targets dialog box displays
The Encryption Targets Disk LUNs dialog box displays
status of the re-key operation.
Pending manual re-key operations
(Figure 153).
(Figure 231).
(Figure 264).The dialog box lists the
Brocade Network Advisor SAN User Manual
53-1002167-01