18
Viewing time left for auto re-key
Viewing time left for auto re-key
You can view the time remaining until auto re-key is no longer active for a disk LUN. The information
is expressed as the difference between the next re-key date and the current date and time, and is
measured in days, hours, and minutes.
Although you cannot make changes directly to the table, you can modify the time left using CLI. For
more information, see the administrator's guide supporting your key vault management system.
To view the time left for auto re-key, follow these steps:
1. Select Configure > Encryption.
2. Select a group, switch, or engine from the Encryption Center Devices table for which to view the
3. Select a target disk device from the table, then click LUNs.
FIGURE 265
560
The Encryption Center dialog box displays
auto re-key information, then select Group/Switch/Engine > Targets from the menu task bar, or
right-click a group, switch, or engine and select Targets.
NOTE
You can also select a group, switch, or engine from the Encryption Center Devices table, then
click the Targets icon.
The Encryption Targets dialog box displays
The Encryption Target Disk LUNs dialog box displays. From this dialog box, you can view the
time left for auto re-key information.
Time left for auto re-key
(Figure
153).
(Figure
231).
Brocade Network Advisor SAN User Manual
53-1002167-01