Editing A Threshold Policy - Brocade Communications Systems Brocade 8/12c User Manual

13. Make the threshold changes by selecting one of the following options:
14. Click OK on the Confirm Threshold Changes dialog box.

Editing a threshold policy

To edit a threshold policy, complete the following steps.
1. Select Monitor > Performance > Configure Thresholds.
2. Select the threshold policy you want to edit in the Available Threshold Policies table.
3. Click Edit.
4. Change the policy type from the Policy Type list.
5. Select a measure from the Measure list.
6. Enter a percentage for the high boundary in the High Boundary field.
7.
8. (Fabric OS only) Enter a percentage for the buffer in the Buffer Size field.
9. Click the right arrow button to move the threshold to the Selected Thresholds table.
10. Repeat steps 5 through 9 for each measure that you want to add to the policy.
11. Click OK on the Edit Threshold Policy dialog box.
Brocade Network Advisor SAN User Manual
53-1002167-01
•
To only add new thresholds, select the Keep currently set thresholds and only add new
thresholds check box.
•
To overwrite all existing thresholds on all fabrics and devices, select the Overwrite all
thresholds currently set on all switches check box.
The Set Threshold Policies dialog box displays.
The Edit Threshold Policy dialog box displays.
FIGURE 355
Edit Threshold Policy dialog box
You cannot add the same measure more than once. If you try to add another threshold with the
same measure, the new values overwrite the older threshold values in the Selected Thresholds
table.
(Fabric OS only) Enter a percentage for the low boundary in the Low Boundary field.
If an error is detected, a message displays informing you to enter a valid value. Click OK to
close this message. Fix any errors and repeat step 9.
Thresholds and event notification
27
809