Tape Pools Tab - Brocade Communications Systems Brocade 8/12c User Manual

18
Viewing and editing group properties
NOTE
The Link Keys tab appears only if the key vault type is NetApp LKM.
The Link Keys tab
access the Link Keys tab, select an LKM group from the Encryption Center Devices table, then
select Group > Link Keys from the menu task bar, or right-click an LKM group and select Link Keys.
The Properties dialog box displays with the Link Keys tab selected.
NOTE
You can also select a group from the Encryption Center Devices table, then click the Properties icon.
FIGURE 275
The Link Keys tab displays a table that shows link key status for each switch in an encryption group.
You must create link keys under the following circumstances:
•
•
•
•
•
Refer to
Establish buttons are used in establishing the trusted link between a switch and LKM.

Tape Pools tab

Tape pools are managed from the Tape Pools tab. From the Tape Pools tab, you can add, modify,
and remove tape pools.
572
(Figure 275) is viewed from the Encryption Group Properties dialog box. To
Encryption Group Properties dialog box - Link Keys tab
When a new encryption group is created.
When a new switch is added to an encryption group.
When a new key vault is added to an encryption group.
After all encryption engines in a switch have been zeroized.
When all of the encryption blades have been removed from a director and one or more new
encryption blades have been added.
"Establishing the trusted link" on page 448 for information on how the Accept and
Brocade Network Advisor SAN User Manual
53-1002167-01