20
Configuring an FCIP tunnel
4. Click Select Switch Two under Switch Two Settings to display discovered extension switches,
5. Enter a description of the tunnel in the Description field.
6. To add a circuit, click Add to the right of the Circuits properties table at the bottom of the dialog
648
FIGURE 288
Add FCIP Tunnel dialog box
and select the switch that you want to connect to switch one.
The switch name and fabric are displayed in the Switch and Fabric fields.
NOTE
You cannot assign a Tunnel ID until after at least one circuit is configured. The Add Circuit
dialog returns you to the Add FCIP Tunnel dialog to allow you to select the Tunnel ID.
box.
The Add FCIP Circuit dialog is displayed. Continue with
"Adding an FCIP
circuit".
Document Title
xx-xxxxxxx-01