Snmp Traps; Adding A Trap Recipient To One Or More Switches - Brocade Communications Systems Brocade 8/12c User Manual

SNMP traps

Simple network management protocol (SNMP) provides a means to monitor and control network
products and to manage configurations, statistics, performance, and security through
authentication and privacy protocols.
The Management application allows you to configure SNMP traps. The SNMP configuration tasks
are described in the following sections.
•
•
•
•
•
•
•
•
•
•
•
•
•
•

Adding a trap recipient to one or more switches

The SNMP Trap Recipients dialog box allows you to register any recipient as a trap recipient on
selected products. You can register different recipients for different products.
NOTE
You can register and unregister other recipient servers on the Fabric OS switches on a per-fabric
basis. For IP products, you can perform registration only at the switch level.
1. Select Monitor > SNMP Setup > Product Trap Recipients.
Brocade Network Advisor SAN User Manual
53-1002167-01
"Defining filters"
"Adding a trap recipient to one or more switches"
"Removing a trap recipient from one or more switches"
"SNMP trap forwarding"
"Adding a trap destination"
"Adding a new trap filter"
"Event reception"
"Adding an SNMP v3 credential"
"Adding an SNMP v1 or v2c community string"
"Importing a new MIB into the Management application"
"Trap customization"
"Unregistering a registered trap"
"Customizing a registered trap definition"
"Reverting the customization of a registered trap to default"
The SNMP Trap Recipients dialog box, shown in
SNMP traps
Figure 372, displays.
30
849