18
Creating a new encryption group
FIGURE 186
Next Steps dialog box
17. Review the post-configuration instructions, which you can copy to a clipboard or print for later.
18. Click Finish to exit the Configure Switch Encryption wizard.
19. Review
"Understanding configuration status results"
on page 503.
Configuring key vault settings for NetApp Link Key Manager (LKM)
The following procedure assumes you have already configured the initial steps in the Configure
Switch Encryption wizard. If you have not already done so, go to
"Creating a new encryption group"
on page 474.
Figure 187
shows the key vault selection dialog box for LKM.
482
Brocade Network Advisor SAN User Manual
53-1002167-01