Brocade Communications Systems Brocade 8/12c User Manual page 560

18
Adding encryption targets
FIGURE 226
7.
8. Click Next.
516
Select Hosts dialog box
Select hosts using either of the following methods:
a. Select a maximum of 1024 hosts from the Hosts in Fabric table, then click the right arrow
to move the hosts to the Selected Hosts table. (The Port WWN column contains all target
information that displays when using the nsshow command.)
b. Manually enter world wide names in the Port WWN and Node WWN text boxes if the hosts
are not included in the table. You must fill in both the Port WWN and the Node WWN. Click
Add to move the host to the Selected Hosts table.
The Name Container dialog box displays
name for the target container that is created in the encryption engine to hold the target
configuration data.
The container name defaults to the target WWPN. You can, however, rename the container
name. Target container names can have up to 31 characters. Letters, digits, and underscores
are allowed.
(Figure 227). The dialog box enables you to specify a
Brocade Network Advisor SAN User Manual
53-1002167-01