Deleting A Zone - Brocade Communications Systems Brocade 8/12c User Manual

19
Zoning administration
3. Enter the maximum number of zone database changes that can be made for that fabric before
4. Repeat
5. To set a limit for new, undiscovered fabrics, enter a value in the Default Change Count for New
6. Select the Enforce change limits during zone activation check box to enforce the change limits.
7.

Deleting a zone

1. Select Configure > Zoning > Fabric.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select an FC fabric from the Zoning Scope list.
4. Select one or more zones in the Zones list that you want to delete, then right-click and select
5. Click Yes to delete the selected zone.
6. Click OK or Apply to save your changes.
616
a zone configuration is activated.
To set a limit, enter a positive integer.
To allow unlimited changes, enter 0.
step 2 and step 3
Fabrics field.
The default value is 0 (Unlimited).
If you want to set the limits now, but turn on enforcement of the limits at a later time, make
sure the check box is clear.
Click OK to save your changes and close the dialog box.
The Zoning dialog box displays.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
Delete.
A message box displays asking you to confirm the deletion.
The message box closes and, if successful, the zone or zones are removed from the Zones list.
NOTE
If you delete something in error, click Cancel on the Zoning dialog box to exit without saving
changes since the last operation (Apply or Activate). When you reopen the dialog box, the zone
is restored.
A message displays informing you that any zones or zone configurations you have changed will
be saved in the zone database, and warning you to make sure no other user is making changes
to the same areas.
for each fabric on which you want to set limits.
Brocade Network Advisor SAN User Manual
53-1002167-01