18
Adding a switch to an encryption group
9. Review important messages, then click Next.
FIGURE 219
10. Review the post-configuration instructions, which you can copy to a clipboard or print for later.
11. Click Finish to exit the Configure Switch Encryption wizard.
12. Review
508
All configuration items have green check marks if the configuration is successful. A red stop
sign indicates a failed step. A message displays below the table, indicating the encryption
switch was added to the group you named, and the public key certificate is stored in the
location you specified.
The Error Instructions dialog box displays
certificates for the encryption switch are displayed. These instructions are specific to the key
vault type.
Error Instructions dialog box
"Understanding configuration status results"
(Figure
219). Instructions for installing public key
on page 503.
Brocade Network Advisor SAN User Manual
53-1002167-01