Brocade Communications Systems Brocade 8/12c User Manual page 898

30
SNMP traps
Adding a new trap filter
The Add Trap Filter dialog box allows you to configure trap filters for forwarding SNMP traps. You
can add trap filters on SAN products, IP products, or Hosts.
1. Select Monitor > SNMP Setup > Trap Forwarding.
2. Click Add in the Trap Filters area of the SNMP Trap Forwarding dialog box.
3. Select the SAN, IP, or Host tab. Depending on the tab selected, the products available to which
4. Enter a unique name for the trap filter in the Filter Name field.
5. Enter a general description of the trap filter in the Description field.
6. Click the Forward Application Messages check box to forward application events.
7.
8. Select a severity level from the Severity list. The severity level can be one of the following, and
854
The SNMP Trap Forwarding dialog box displays.
The Add Trap Filter dialog box, shown in
FIGURE 375
Add Trap Filter dialog box
you can add a trap filter display in the Available Products list.
Click the Forward pseudo events check box to forward pseudo events.
appear in descending order of severity.
•
Emergency
•
Alert
•
Critical
•
Error
Figure 375, displays.
Brocade Network Advisor SAN User Manual
53-1002167-01