Enabling Or Disabling Safe Zoning Mode For Fabrics - Brocade Communications Systems Brocade 8/12c User Manual

6. Make sure the appropriate fabric is named on the Zoning Policies dialog box.
7.
8. Click OK or Apply to save your changes.

Enabling or disabling safe zoning mode for fabrics

NOTE
Safe Zoning Mode is available only on devices running in McDATA Fabric Mode and, for pure EOS
fabrics, in McDATA Open Mode.
1. Select Configure > Zoning > Fabric.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select an FC fabric from the Zoning Scope list.
4. Click Zoning Policies.
5. Make sure the appropriate fabric is named on the Zoning Policies dialog box.
6. Perform one of the following actions based on the task you want to complete:
7.
8. Click OK or Apply on the Zoning dialog box to save your changes.
Brocade Network Advisor SAN User Manual
53-1002167-01
Perform one of the following actions based on the task you want to complete:
•
To enable the default zone, click Enable, and then click OK.
•
To disable the default zone, click Disable, and then click OK.
The Zoning Policies dialog box closes and the Zone DB tab displays.
A message displays informing you that any zones or zone configurations you have changed will
be saved in the zone database, and warning you to make sure no other user is making changes
to the same areas.
The Zoning dialog box displays.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
The Zoning Policies dialog box displays.
NOTE
The format and content of this dialog box vary slightly depending on Interop Mode and the
target selected in the Zoning Scope list.
•
To enable Safe Zoning Mode, click Enable, and then click OK.
•
To disable Safe Zoning Mode, click Disable, and then click OK.
Click OK to apply your changes and close the Zoning Policies dialog box.
Zoning configuration
19
589