Adding Encryption Targets - Brocade Communications Systems Brocade 8/12c User Manual

Adding encryption targets

Adding an encryption target maps storage devices and hosts to virtual targets and virtual initiators
within the encryption switch.
NOTE
It is recommended that you configure the host and target in the same zone before configuring them
for encryption. If the host and target are not already in the same zone, you can still configure them
for encryption, but you will need to configure them in the same zone before you can commit the
changes. If you attempt to close the Encryption Targets dialog box without committing the changes,
you are reminded of uncommitted changes in the Management application.
1. Select Configure > Encryption from the menu task bar.
2. Select a group, switch, or engine from the Encryption Center Devices table to which to add the
FIGURE 222
3. Click Add.
Brocade Network Advisor SAN User Manual
53-1002167-01
The Encryption Center dialog box displays
target, then select Group/Switch/Engine > Targets from the menu task bar, or right-click a
group, switch, or engine and select Targets.
NOTE
You can also select a group, switch, or engine from the Encryption Center Devices table, then
click the Targets icon.
The Encryption Targets dialog box displays
Encryption Targets dialog box
The Configure Storage Encryption wizard dialog box displays. The dialog box explains the
wizard's purpose, which is to configure encryption for a storage device (target).
Adding encryption targets
(Figure 153).
(Figure 222).
18
513