6. Click Apply or OK to save your work.
7.
Configuring asset polling
NOTE
Asset polling is only applicable for SAN products.
Asset polling allows you set the length of time between state change polling. To maximize the
efficiency of the polling feature (balance the amount of possible information with any possible
performance impact), base your settings on the size of the SAN.
To configure asset polling, complete the following steps.
1. Select Server > Options.
2. Select Memory Allocation in the Category list to set the memory allocation for the server and
3. Enter how often you want to check for state changes in the Check for state change every field.
4. Enter how often (default is 120 seconds) you want to check for state changes in the If no state
Brocade Network Advisor SAN User Manual
53-1002167-01
•
Enterprise Medium : 1500 MB
•
Enterprise Large : 2048 MB
NOTE
There is no restriction on the maximum value for Server Heap Size in a 64-Bit Server. The
correct server heap size value must be given according to the RAM present in the server.
NOTE
Changes to this option take effect after an application restart.
NOTE
You can only restart the server using the Server Management Console (Start > Programs >
Management_Application_Name 11.X.X > Server Management Console).
Click OK on the "changes take effect after application restart" message.
The Options dialog box displays.
client.
You cannot enter a value lower than the default minimum value. Default for Professional is 60
seconds.
Default minimum values are as follows:
•
Small: 60 seconds
•
Medium: 120 seconds
•
Large: 180 seconds
change, Poll switch every field.
Default values are as follows:
•
Small: 120 seconds
•
Medium: 900 seconds
•
Large: 1800 seconds
Software Configuration
4
121