Saving A Master Key To A Smart Card Set - Brocade Communications Systems Brocade 8/12c User Manual

FIGURE 251
4. Select Key Vault as the Backup Destination.
5. Enter the passphrase, which is required for restoring the master key. The passphrase can be
6. Re-enter the passphrase for verification.
7.
8. Store both the Key ID and the passphrase in a secure place. Both will be required to restore the
9. Click OK. after you have copied the Key ID.

Saving a master key to a smart card set

A card reader must be attached to the SAN Management application PC to complete this
procedure. Recovery cards can only be written once to back up a single master key. Each master
key backup operation requires a new set of previously unused smart cards.
NOTE
Windows operating systems do not require smart card drivers to be installed separately; the driver
is bundled with the operating system. However, you must install a smart card driver for Unix
operating systems. For instructions, refer to the Installation Guide.
Brocade Network Advisor SAN User Manual
53-1002167-01
Backup Destination (to key vault) dialog box
between eight and 40 characters, and any character is allowed.
Click OK.
A dialog box displays that shows the Key ID. The Key ID identifies the storage location in the key
vault.
master key in the future. (The Key ID identifies the storage location in the key vault.)
18
Master keys
543