Brocade Communications Systems Brocade 8/12c User Manual page 387

7.
8. Select the VLAN you created and click Edit to convert the VLAN to FCoE VLAN.
9. Select the FCoE check box.
10. Select the DCB interface to carry the FCoE traffic from the Selection List and click Add to add it
11. Click OK on the VLAN Configuration dialog box to save your changes.
12. Close Web Tools.
Creating VLAN classifiers and activating on the DCB interface
NOTE
This procedure is completed using the CLI. This procedure is applicable for FOS versions lower than
FOS 7.0.
To create and activate the VLAN classifiers on the DCB interface, complete the following steps.
1. Log into the switch and enter global configuration mode.
2. Create and apply VLAN Classifiers to the DCB interface to classify Ethernet frames on an
3. Apply the VLAN classifier Group to the DCB interface.
4. Save the running-config file to the startup-config file.
Brocade Network Advisor SAN User Manual
53-1002167-01
Click OK on the VLAN Configuration dialog box.
The VLAN Configuration dialog box displays.
to the Selected List.
Example
switch:<userid>>cmsh
switch#configure terminal
untagged interface to VLAN.
Example
switch(config)#vlan classifier rule 1 proto fip encap ethv2
switch(config)#vlan classifier rule 2 proto fcoe encap ethv2
switch(config)#vlan classifier group 1 add rule 1
switch(config)#vlan classifier group 1 add rule 2
Example of activating VLAN classifier on the interface Te 0/7
switch(conf-if-te-0/7)#vlan classifier activate group 1 vlan 1002
Example
switch#copy running-config startup-config
14
Switch policies
343