Changing The Allow/Prohibit Matrix Display; Changing Window Arrangement; Clearing Port Names - Brocade Communications Systems Brocade 8/12c User Manual

Changing the Allow/Prohibit Matrix display

You can modify the display using the Window Arrangement list above the matrix display or the Clear
all port names option below the display.
NOTE
If you receive a 'FICON not supported on switch' error, refer to FICON troubleshooting for a list of
possible causes.

Changing window arrangement

There are three options for the Allow/Prohibit Matrix display on the Configure Allow/Prohibit Matrix
dialog box located in the Window Arrangement list above the display.
•
•
•
Perform the following steps to change the display to the desired format.
1. Select Configure > Allow/Prohibit Matrix.
2. Select Cascade, Tile Horizontally, or Tile Vertically from the Window Arrangement list.

Clearing port names

Select the Clear Port Names option below the matrix display to clear all port names from the
selected matrix.
Perform the following steps to change the display to the desired format.
1. Select Clear Port Names.
2. Select Yes to clear all port names from the matrix or select No to cancel the operation.
Brocade Network Advisor IP User Manual
53-1002168-01
The matrix definitions may be cascaded (this is the default view).
The matrix definitions may be tiled horizontally.
The matrix definitions may be tiled vertically.
The Configure Allow/Prohibit Matrix dialog box displays.
A warning displays asking you to confirm the operation.
Changing the Allow/Prohibit Matrix display
23
713