Brocade Communications Systems Brocade 8/12c User Manual page 873

6. Choose one of the following options:
7.
Brocade Network Advisor SAN User Manual
53-1002167-01
•
To use the default frequency (one time, runs at current system time plus fifteen minutes),
go to step 7.
•
To configure the frequency, click the ellipsis button and choose one of the following
options to configure the frequency at which deployment runs for the policy monitor:
To configure deployment to run only once, refer to

monitor schedule"
To configure hourly deployment, refer to

schedule" on page 840.
To configure daily deployment, refer to

on page 840.
To configure weekly deployment, refer to

schedule" on page 840.
To configure monthly deployment, refer to

schedule" on page 841.
To set policy monitors for fabrics, select the Fabric Checks tab and complete the following
steps.
a. Select the Check zoning status check box to determine if zoning is enabled or disabled on
the fabric.
•
Select the Enabled option to determine if zoning is enabled.
•
Select the Disabled option to determine if zoning is disabled.
b. Select the Check that all zones belong to at least one zone config check box to determine
if there are orphaned zones in the fabric zone database.
c. Select the Check the number of initiator ports zoned to each storage port check box to
determine the total number of initiator ports zoned to each storage port.
d. Enter the initiator port limit in the Initiator Port Limit field.
The default recommended is 20.
e. Select the fabrics to which you want to apply this policy in the Available Fabrics table and
click the right arrow button.
The selected fabrics display in the Selected Fabrics table.
on page 839.
"Configuring an hourly policy monitor
"Configuring a daily policy monitor schedule"
"Configuring a weekly policy monitor
"Configuring a monthly policy monitor
Adding a policy monitor
"Configuring a one-time policy
29
829