Adding An Event Report Schedule - Brocade Communications Systems Brocade 8/12c User Manual

Adding an event report schedule

The Add Schedule dialog box, shown in
and configure the parameters for when the report is run and to whom the report is sent.
1. Select Reports > Event Custom Reports.
2. Click the Schedules tab.
3. Click the Add button.
4. Enter the name of the new schedule in the Name field. You must enter a unique name for the
5. Select the Suspend schedule check box if you want to disable the schedule. For example, you
6. Select the report definition you want to schedule from the Report Definition list. If a report is
7.
Brocade Network Advisor SAN User Manual
53-1002167-01
The Event Custom Reports dialog box displays.
The Add Schedule dialog box displays.
FIGURE 404
Add Schedule dialog box
schedule. The name can be up to 64 characters in length and it is case-sensitive.
may want to temporarily prevent a report from being generated until further notice. You can
clear the check mark to resume the automatic generation of the report.
deleted, the corresponding schedule will be deleted.
Select one of the following periods from the Frequency list:
•
One Time
•
Hourly—If you selected Hourly as the schedule type, Minutes past the hour appears. Select
the minutes after the hour when the definition report will be generated.
•
Daily—If you selected Daily as the schedule type,Time (hh:mm) appears.
Event custom report schedules
Figure 404, allows you to select an existing report definition
30
901