Brocade Communications Systems Brocade 8/12c User Manual page 754

23
Saving or Copying Allow/Prohibit Matrix configurations to another device
4. Enter a name for the configuration.
5. Enter a description for the configuration.
6. Select the check box for the switch to which you want to save the configuration in the Select
7.
Saving an Allow/Prohibit Matrix configuration to another device
NOTE
If you receive a 'FICON not supported on switch' error, refer to FICON troubleshooting for a list of
possible causes.
To save an existing Allow/Prohibit Matrix configuration to another device, complete the following
steps.
1. Select Configure > Allow/Prohibit Matrix.
2. Select the Allow/Prohibit Matrix configuration you want to copy.
3. Click Save As.
710
FIGURE 329
Save As/Duplicate dialog box
Switch table.
Click OK.
A message displays stating that the outstanding port configuration is discarded when copying
a configuration from the switch with more ports to a switch with fewer ports and vice versa.
Click OK to close the message.
The copied configuration displays in the Available Switches table under the selected switch. To
edit this configuration, refer to
"Configuring an Allow/Prohibit Matrix manually"
The Configure Allow/Prohibit Matrix dialog box displays.
You can do this by expanding the view for the switch under Available Switches and selecting a
configuration, or you may select the matrix under Allow/Prohibit Matrix.
The Save As/Duplicate dialog box displays.
"Configuring an Allow/Prohibit Matrix"
on page 707.
on page 706 or
Brocade Network Advisor IP User Manual
53-1002168-01