30
SNMP traps
2. Click Add from the Action list.
3. Enter the IP address of the SNMP trap receiver (the recipient server) in the Recipient IP
4. Enter the SNMP trap port of the recipient in the Recipient Port field. This is a mandatory field.
5. Select the fabric or switches from the Available list and click the right arrow button to move it to
6. If the selected product is a SAN fabric, select a severity from the Severity list. Severity levels
7.
8. Click OK.
850
FIGURE 372
SNMP Trap Recipients dialog box
Address field. This is a mandatory field. IPv4 addresses are accepted, but a Domain Name
System (DNS) name is not accepted.
Valid numeric values range from 1 through 65535 and 162 is the default.
the Selected list. You can select multiple products.
NOTE
For IP products and product groups, only switches are available to select.
can be one of the following: None, Critical, Error, Warning, Info, or Debug. The Severity list is
disabled for IP products (None is the default).
Click the View Recipients button to list the recipients that correspond to a selected fabric or
product from the Available list.
The Trap Recipients - Fabric dialog box or the Trap Recipients - IP address dialog box
(depending on which product you selected), displays a list of configured recipients.
The Management application registers the recipient IP address as an SNMP trap recipient. The
SNMP version and credentials from the SNMP profile (for example, SNMP v3) are registered.
Brocade Network Advisor SAN User Manual
53-1002167-01