18
Adding a switch to an encryption group
Adding a switch to an encryption group
The setup wizard allows you to either create a new encryption group, or add an encryption switch to
an existing encryption group. Use the following procedure to add a switch to an encryption group:
1. Select Configure > Encryption from the menu task bar.
2. Select a switch to add from the Encryption Center Devices table, then select Switch >
FIGURE 213
3. Click Next.
504
The Encryption Center dialog box displays
Create/Add to Group from the menu task bar, or right-click a switch and select Create/Add to
Group.
NOTE
The switch must not already be in an encryption group.
The Configure Switch Encryption wizard welcome panel displays
Configure Switch Encryption wizard - welcome panel
The Designate Switch Membership dialog box displays
(Figure
153).
(step
(Figure
214).
Brocade Network Advisor SAN User Manual
213).
53-1002167-01