18
Tape LUN write early and read ahead
FIGURE 243
4. In the Enable Write EarlyAck and Enable Read Ahead columns, when the table is populated,
5. Click OK.
6. Commit the changes on the related crypto target container:
For more information, refer to the following topics:
•
•
534
Encryption Target Tape LUNs dialog box - Setting tape LUN read ahead and write early
you can set these features as desired for each LUN:
•
To enable write early for a specific tape LUN, select Enable Write Early Ack for that LUN.
•
To enable read ahead for a specific LUN, select Enable Read Ahead for that LUN.
•
To disable write early for a specific tape LUN, deselect Enable Write Early Ack for that LUN.
•
To disable read ahead for a specific LUN, deselect Enable Read Ahead for that LUN.
a. Select Configure > Encryption from the menu task bar.
The Encryption Center dialog box displays
b. Select a group, switch, or engine from the Encryption Center Devices table that contains
the storage device to be configured, then select Group/Switch/Engine > Targets from the
menu task bar, or right-click a group, switch, or engine and select Targets.
NOTE
You can also select a group, switch, or engine from the Encryption Center Devices table, then
click the Targets icon.
c.
Select the appropriate crypto target container.
d. Click Commit.
"Tape LUN write early and read ahead"
"Using the Encryption Targets dialog box"
(Figure
153).
on page 533
on page 552
Brocade Network Advisor SAN User Manual
53-1002167-01