Adding Target Tape Luns For Encryption - Brocade Communications Systems Brocade 8/12c User Manual

Adding target tape LUNs for encryption

You configure a Crypto LUN by adding the LUN to the CryptoTarget container and enabling the
encryption property on the Crypto LUN. You must add LUNs manually. After you add the LUNs, you
must specify the encryption settings.
When configuring a LUN with multiple paths, the same LUN policies must be configured on all
paths to the LUN. If there are multiple paths to the same physical LUNs, then the LUNs are added
to multiple target containers (one target per storage device port).
1. Select Configure > Encryption from the menu task bar.
2. Select a group, switch, or engine from the Encryption Center Devices table that contains the
FIGURE 239
3. Select a target tape storage device from the Encryption Targets table, then click LUNs.
Brocade Network Advisor SAN User Manual
53-1002167-01
The Encryption Center dialog box displays
storage device to be configured, then select Group/Switch/Engine > Targets from the menu
task bar, or right-click a group, switch, or engine and select Targets.
NOTE
You can also select a group, switch, or engine from the Encryption Center Devices table, then
click the Targets icon.
The Encryption Targets dialog box displays
Encryption Targets dialog box
The Encryption Target Tape LUNs dialog box displays
Adding target tape LUNs for encryption
(Figure 153).
(Figure 239).
(Figure 240).
18
529