Brocade Communications Systems Brocade 8/12c User Manual page 394

14
Switch policies
5. Continue to configure the following LAG parameters. These parameters are disabled until you
6. Click OK .
7.
8. Click Start on the Deployment Status dialog box to save the changes to the selected LAG or
9. Click Close to close the Deployment Status dialog box.
350
•
L2 Mode - Select the L2 mode (Access or Trunk).
Access mode allows only one VLAN and allows only untagged frames.

Trunk mode allows more than one VLAN association and allows tagged frames.

•
Primary - Enter the primary IP address assigned to an L3 port.
NOTE
Primary and secondary IP fields are applicable only to the external ports and the interface
mode must be L3 to enable these fields.
•
Secondary - Enter the secondary IP address (optional). Multiple (secondary) IP addresses
help when the interface and port are part of multiple subnets.
add a DCB port to the LAG members table.
•
Mode - The ports that are LAG members are in either Static or Dynamic mode. You cannot
change the mode on existing members of a LAG.
If the mode is set as Dynamic, you can change the dynamic mode type (to Active or
Passive) only for newly-added ports, not for existing port members of a LAG.
•
Type - The type value options are Standard, where the LAG is limited to 16 ports, and
Brocade, where the LAG is limited to four ports. The default is Standard. The type is set
when you add a LAG; you cannot edit the type using the Edit LAG dialog box.
The Deploy to LAGs dialog box displays.
Click OK after changing the attributes of the current deployment.
The Deployment Status dialog box launches.
LAGs.
NOTE
If the primary or secondary IP address already exists on another interface, an error message
displays in the Status area.
Brocade Network Advisor SAN User Manual
53-1002167-01