Configuring Key Vault Settings For Hp Secure Key Manager (Skm)487 - Brocade Communications Systems Brocade 8/12c User Manual

10. Verify the information, then click Next.
FIGURE 192
11. Review the post-configuration instructions, which you can copy to a clipboard or print for later.
12. Click Finish to exit the Configure Switch Encryption wizard.
Configuring key vault settings for HP Secure Key Manager (SKM)
The following procedure assumes you have already configured the initial steps in the Configure
Switch Encryption wizard. If you have not already done so, go to
on page 474.
Figure 193
Brocade Network Advisor SAN User Manual
53-1002167-01
All configuration items have green check marks if the configuration is successful. A red stop
sign indicates a failed step. A message displays below the table, indicating the encryption
switch was added to the group you named, and the public key certificate is stored in the
location you specified.
After configuration of the encryption group is completed, the Management application sends
API commands to verify the switch configuration. See
results" on page 503 for more information.
The Next Steps dialog box displays
certificates for the encryption switch are displayed. These instructions are specific to the key
vault type.
Next Steps dialog box
shows the key vault selection dialog box for SKM.
Creating a new encryption group
"Understanding configuration status
(Figure 192). Instructions for installing public key
"Creating a new encryption group"
18
487