SAN End node display
The connectivity map can be configured to display or not display end nodes. This option enables
you to set the end node display for all newly discovered fabrics. Note that disabling end node
display limits the connectivity map to emphasize switch members only.
Displaying end nodes
To display end nodes when discovering a new fabric, complete the following steps.
1. Select Server > Options.
FIGURE 36
2. Select SAN End Node Display in the Category list.
3. Select the Show connected end nodes when new fabric is discovered check box to display end
4. Click Apply or OK to save your work.
Brocade Network Advisor SAN User Manual
53-1002167-01
The Options dialog box displays
Options dialog box (SAN End Node Display option)
nodes on your system.
NOTE
Before changes can take effect, the topology must be rediscovered.
(Figure
36).
SAN End node display
4
93