9. Select the Key Vault Type. Configuration options vary based on the key vault type you choose.
Configuring key vault settings for RSA Key Manager (RKM)
The following procedure assumes you have already configured the initial steps in the Configure
Switch Encryption wizard. If you have not already done so, go to
on page 474.
Figure 180
FIGURE 180
1. Enter the IP address or host name for the primary key vault. If you are clustering RKM
2. Enter the name of the file that holds the Primary Key Vault's CA Key Certificate or browse to the
Brocade Network Advisor SAN User Manual
53-1002167-01
To complete the wizard steps, proceed to the section that describes your particular key vault
type. Key vault types are:
-
RSA Key Manager (RKM). For RKM key vault setting instructions, see
vault settings for RSA Key Manager (RKM)"
-
NetApp Link Key Manager (LKM). For LKM key vault setting instructions, see
key vault settings for NetApp Link Key Manager (LKM)"
-
HP Secure Key Manager (SKM). For SKM key vault setting instructions, see
key vault settings for HP Secure Key Manager (SKM)"
-
Thales Encryption Manager for Storage (TEMS). For TEMS key vault setting instructions,
see
"Configuring key vault settings for Thales Key Manager (TEMS)"
-
Tivoli Key Lifetime Manager (TKLM). For TKLM key vault setting instructions, see
"Configuring key vault settings for IBM Tivoli Key Lifetime Manager (TKLM)"
shows the key vault selection dialog box for RKM.
Select Key Vault dialog box for RKM
appliances for high availability, IP load balancers are used to direct traffic to the appliances.
Use the IP address of the load balancer.
desired location.
Creating a new encryption group
on page 477.
on page 482.
on page 487.
on page 492.
"Creating a new encryption group"
18
"Configuring key
"Configuring
"Configuring
on page 497.
477