Enabling A Call Home Center; Enabling Support Save - Brocade Communications Systems Brocade 8/12c User Manual

7.
8. Click Send Test to test the address.
9. Click OK.
10. Click OK to close the Call Home dialog box.

Enabling a call home center

To enable a call home center, complete the following steps.
1. Select Monitor > Event Notification > Call Home.
2. Select the Enable check box of the call home center you want to enable in the Call Home
3. Click OK to close the Call Home dialog box.

Enabling support save

NOTE
Only supported on Fabric OS switches with firmware 5.2 or later.
When you enable Support Save through the call home center, all call home events trigger the
Support Save operation and the Support Save stored location on the FTP server is transmitted with
the call home event.
To enable a support save for a call home center, complete the following steps.
1. Select Monitor > Event Notification > Call Home.
2. Select the Support Save check box of the call home center or device for which you want to
3. Click OK to close the Call Home dialog box.
Brocade Network Advisor SAN User Manual
53-1002167-01
Enter the port number (default is 2069) of the call home center in the Port field
The selected call home center must be enabled to test the IP address.
A faked event is generated and sent to the selected call home center. You must contact the call
home center to verify that the event was received and in the correct format.
NOTE
The HP LAN Call Home alert displays the directory separation characters with a double
backslash (\\) instead of a single backslash (\).
The Call Home dialog box displays with the call home center you edited highlighted in the Call
Home Centers table.
The Call Home dialog box displays.
Centers table.
The Call Home dialog box displays.
enable support save in the Call Home Centers table.

Enabling a call home center

6
167