Configure Mpls Ldp Acl - Extreme Networks ExtremeWare Command Reference Manual

configure mpls ldp acl

configure mpls ldp acl [enabled | disabled]
Description
Enables or disables an MPLS LDP Access Control List (ACL).
Syntax Description
enabled
disabled
Default
N/A.
Usage Guidelines
This command enables or disables an MPLS LDP Access Control List (ACL). The enabled keyword
specifies that the ACL be enabled. When enabled, all required authentication procedures are enforced.
LDP ACLs cannot be enabled unless at least one LDP ACL peer has been configured. The disabled
keyword specifies that the ACL be disabled. No authentication procedures are enforced. LDP ACLs
must be disabled before all LDP ACL peers can be deleted. Changing the ACL enabled configuration
may result in the termination of sessions or services with peers that cannot be validated. The LDP ACL
status is displayed using the show mpls command.
Example
None
History
This command was first available in an ExtremeWare 7.3.0.
Platform Availability
This command is available on the BlackDiamond switch only.
ExtremeWare 7.5 Command Reference Guide
Enables MPLS LDP ACL such that all required authentication procedures are
enforced.
Disables MPLS LDP ACL.
configure mpls ldp acl
2379