Configure Lldp Ports Vendor-Specific Dot3 Mac-Phy - Extreme Networks ExtremeWare Command Reference Manual

LLDP Commands

configure lldp ports vendor-specific dot3 mac-phy

configure lldp ports [all | <portlist>] [advertise | no-advertise]
vendor-specific dot3 mac-phy
Description
Configures LLDP ports to advertise or not advertise MAC and physical layer capabilities to its
neighbors. The capabilities include duplex and bit-rate. Since this is a vendor specific option, there may
not be support for this from the neighbor.
Syntax Description
all
portlist
advertise
no-advertise
Default
The default is not to advertise.
Usage Guidelines
N/A.
Example
The following command configures all ports to advertise MAC/PHY capabilities to
neighbors.
configure lldp ports all advertise vendor-specific dot3 mac-phy
History
This command was first available in ExtremeWare 7.4.
Platform Availability
This command is available on all Extreme switches.
2348
Applies to all ports on the switch.
Specifies a list of switch ports in the form i:*, i:n, or i:n-i-m.
Specifies that information is to be sent to neighbors.
Specifies that information is not to be sent to neighbors.
ExtremeWare 7.5 Command Reference Guide