Config Pim Add Vlan - Extreme Networks ExtremeWare Command Reference Manual

config pim add vlan

config pim add vlan [<vlan name> | all] {dense | sparse}
Description
Enables PIM on an IP interface.
Syntax Description
vlan name
all
dense
sparse
Default
Dense.
Usage Guidelines
When an IP interface is created, per-interface PIM configuration is disabled by default.
The switch supports both dense mode and sparse mode operation. You can configure dense mode or
sparse mode on a per-interface basis. After they are enabled, some interfaces can run dense mode, while
others run sparse mode.
Example
The following command enables PIM-DM multicast routing on VLAN accounting:
config pim add vlan accounting dense
History
This command was first available in ExtremeWare 4.0.
Platform Availability
This command is available on all platforms.
ExtremeWare Software 7.0.0 Command Reference Guide
Specifies a VLAN name.
Specifies all VLANs.
Specifies PIM dense mode (PIM-DM).
Specifies PIM sparse mode (PIM-SM).
config pim add vlan
1143