Show Lldp Ports - Extreme Networks ExtremeWare Command Reference Manual

LLDP Commands

show lldp ports

show lldp ports [all | <portlist>] {detailed}
Description
Displays LLDP configuration information for the specified port or ports. The
to show the configured VLANs on the port and the enabled VLAN specific TLVs.
Syntax Description
all
portlist
detailed
Default
N/A.
Usage Guidelines
N/A.
Example
The following example displays LLDP configuration information for port 5:23.
# show lldp ports 5:23
LLDP Configuration
Advertised Interval : 30 seconds
Hold Value : 4
Transmit Delay : 2 seconds
Notification Interval : 5 seconds
Re-init Delay : 2 seconds
Port Tx
State
======================================================================================
5:23 ENABLED
======================================================================================
Flags: (P) Port Description, (N) System Name, (D) System Description
(C) System Capabilities, (M) Mgmt Addr
802.1 Flags: (P) Port VLAN ID, (p) Port & Porocotol VLAN ID, (N) VLAN Name
2366
Applies to all ports on the switch.
Specifies a list of switch ports in the form i:*, i:n, or i:n-i-m.
Shows information on the configured VLANs on the port.
Rx SNMP
State Notification
ENABLED DISABLED
U->page up D->page down ESC->exit
detailed
Optional enabled transmit TLVs
LLDP 802.1
PNDCM NPp-
keyword is used
802.3
----
ExtremeWare 7.5 Command Reference Guide