Configure Inline-Power Usage-Threshold - Extreme Networks ExtremeWare Command Reference Manual

Power Over Ethernet Commands—Summit 300 and 400-24p Switches and Alpine PoE Module

configure inline-power usage-threshold

configure inline-power usage-threshold <threshold>
Description
Sets the inline power usage alarm threshold.
NOTE
This command is available only for the Alpine FM-32Pi PoE Module and the Summit 300-48 switch.
Syntax Description
threshold Integer in the range 1 – 99 expressed as a percentage for derating of available power to measured
power. The default value is 70 on the Summit 300-48 switch, the Summit 400-24p switch, or the
Alpine series I/O modules. The default value is 90 on the Summit 300-24 switch.
Default
Alpine series FM-32Pi PoE Module: 70
Summit 300-24 switch: 90
Summit 300-48 switch: 70
Summit 400-24p switch: 70
Usage Guidelines
This command sets the threshold for initiation of an alarm if the measured power exceeds the threshold.
On the Alpine FM-32Pi PoE Module and the Summit 300-48 switch, the alarm threshold is shared
between the system-level utilization and the allocated power budget per slot. If either measurement
exceeds the threshold level, an alarm will be initiated.
On the Summit 400-24p switch, the usage threshold is not shared with the system usage; rather, it is
power used by the PDs only.
Example
The following command sets the inline power usage alarm threshold at 75%:
configure inline-power usage-threshold 75
History
This command was first available in ExtremeWare 7.2.
This command was added to the Summit "e" series of switches in ExtremeWare 7.3e.
Platform Availability
This command is available only on Alpine FM32-Pi PoE Modules and the Summit 300-48 switch.
2292 ExtremeWare 7.5 Command Reference Guide