Configure Inline-Power Type - Extreme Networks ExtremeWare Command Reference Manual

Power Over Ethernet Commands—Summit 300 and 400-24p Switches and Alpine PoE Module

configure inline-power type

configure inline-power type [phone | webcam | wireless | other] ports
<portlist>
Description
Sets the type of powered device (PD) connected to the specified ports.
NOTE
This command is available only for the Alpine FM-32Pi PoE Module and the Summit 300-48 switch.
Syntax Description
phone Specifies the PD connected to the specified port as a phone.
webcam Specifies the PD connected to the specified port as a webcam.
wireless Specifies the PD connected to the specified port as a wireless device.
other Specifies the PD connected to the specified port as a power device other than a phone, a webcam,
or a wireless device.
portlist Specifies one or more slots and ports. May be in the form 2:*, 2:5, 2:6-2:8.
Default
N/A
Usage Guidelines
This command sets the type of powered device connected to the specified ports. This is a
management-controlled entity because there is no support for dynamically determining the powered
device type.
Use the argument in the
detail port
command to display the inline-power type for a selected port.
<portlist]
Examples
The following command specifies the type of powered device connected to port 3 on slot 4 as a wireless
device on an Alpine switch:
configure inline-power type wireless ports 4:3
The following command specifies the type of powered device connected to port 3 as a wireless device
on a Summit 300-48 switch:
configure inline-power type wireless ports 1:3
History
This command was first available in ExtremeWare 7.2.
This command was added to the Summit "e" series of switches in ExtremeWare 7.3e.
2290
show inline-power info [port <portlist | detail port
ExtremeWare 7.5 Command Reference Guide