Configure Inline-Power Reserved Budget - Extreme Networks ExtremeWare Command Reference Manual

configure inline-power reserved budget

configure inline-power reserved budget <milliwatts> ports <portlist>
Description
Sets the reserved power on the specified ports to either the default value or the specified watts.
NOTE
This command is available only for the Alpine FM-32Pi PoE Module and the Summit 300-48 switch.
Syntax Description
milliwatts An integer specifying milliwatts at zero (0) or in the range of 3000 – 20000 mW.
portlist Specifies one or more slots and ports. May be in the form 2:*, 2:5, 2:6-2:8.
Default
0 mW
Usage Guidelines
This command sets the reserved power on the specified ports to either the default value or the specified
watts. The reserved power range is 0 or 3000-20000 mW. The default reserved power range value is 0
mW. Total power reserved may be up to but not greater than the total power for the module. If all the
power available to the module is reserved, the common power pool is empty.
Example
The following command sets the reserved power for all the ports on slot 4 to 15000 mW:
config inline-power reserved budget 15000 ports 4:*
History
This command was first available in ExtremeWare 7.2.
This command was added to the Summit "e" series of switches in ExtremeWare 7.3e.
Platform Availability
This command is available only on Alpine FM32-Pi PoE Modules and the Summit 300-48 switch.
ExtremeWare 7.5 Command Reference Guide
configure inline-power reserved budget
2289