Show Ports Egress-Rate-Limit - Extreme Networks ExtremeWare Command Reference Manual

High-Density Gigabit Ethernet Commands—Alpine 3800 and BlackDiamond 6800 Series Only

show ports egress-rate-limit

show ports {<portlist>} egress-rate-limit
Description
Displays the maximum egress rate limit on the specified
Syntax Description
portlist Specifies one or more slots and ports. May be in the form 2:*, 2:5, 2:6-2:8.
Default
N/A
Usage Guidelines
Depending on the port egress rate limit configuration, the maximum port bandwidth is displayed in the
numeric rate (kbps or mbps) or the percentage rate.
This command applies only to
aggregate of all outgoing traffic on a port.
This display is independent of any "i" series egress rate-limiting configurations that you have on the
switch.
Example
The following command displays the maximum egress rate limit:
show ports egress-rate-limit
Following is sample output from this command:
PORT Egress-Rate
=====================
2:1 100 %
2:2 100 %
2:3 100 %
2:4 1000 k
2:5 100 %
2:6 10 m
2:7 100 %
2:8 100 %
2:9 100 %
2:10 100 %
2:11 100 %
2:12 100 %
2:13 100 %
2:14 100 %
2:15 100 %
2:16 100 %
2262
"3"
series I/O modules; the rate you configure is applicable to the
"3"
series ports.
ExtremeWare 7.5 Command Reference Guide