Disable Inline-Power Legacy - Extreme Networks ExtremeWare Command Reference Manual

Power Over Ethernet Commands—Summit 300 and 400-24p Switches and Alpine PoE Module

disable inline-power legacy

disable inline-power legacy
Description
Disables legacy (802.3af compliant) devices from being detected by the PoE subsystem.
NOTE
This command is available only for the Summit 300-24 and 400-24p switches.
Syntax Description
This command has no arguments or variables.
Default
Disabled
Usage Guidelines
The Summit 300-24 or 400-24p switch can power devices that are compliant with the IEEE 802.3af
Power over Ethernet standard. The
devices built before the standard was approved.
If all the devices connected to the switch are 802.3af standards compliant, it is advisable to keep the
default setting of disabled for legacy device support.
You can determine whether a device connected to the switch is standards compliant or not by using the
show inline-power info [port <portlist | detail port <portlist]
status line shows if the device is 802.3af standards compliant.
Sample output from the show inline-power info detail ports command follows:
t show inline-power info detail ports 5
Summi 300-24:3 #
PORT - 5
Configured Admin State: Enabled
Inline Power State: delivering
MIB Detect Status: delivering
Label:
Violation Precedence: max-class-operator
Operator Limit: 15400 milliwatts
Inline Type: other
PD Class: class3
Max Allowed Power: 15.400 W
Measured Power: 6.90 W
Line Voltage: 50.2 Volts
Current: 117 mA
Fault Status: None (D 0)
Detailed Status: valid resistor detected, 802.3af-compliant PD was detected
2296
enable inline-power legacy
command allows powering of PoE
command. The detailed
ExtremeWare 7.5 Command Reference Guide