Message (Part Code Group 6Nnn); Part Code 6005 - HP StorageWorks P9000 - Disk Arrays Manual

8 Message (part code group 6nnn)

This chapter includes the error messages with the part code 6005 to 6810.

Part code 6005

Table 50 Error codes (part code 6005)
Part Error
Code Number
6005 5013
6005 5099
6005 5145
6005 6000
6005 6012
6005 6023
6005 8000
6005 8001
6005 8100
6005 8104
6005 8700
6005 8701
6005 8702
Error Message
An error occurred during SVP
processing.
An error occurred during SVP
processing.
This function does not support the
specified port.
An error occurred during SVP
processing.
An error occurred during SVP
processing.
The SVP is busy. Please wait for a while,
and then retry the operation.
Time out error.
Time out error.
Time out error.
The storage system has accepted the
request normally, however the processing
requires some time. Wait for a while,
then refresh the window and confirm the
pair status has been changed properly.
If the pair status is not changed despite
refreshing the window, check the MCU
or RCU configuration and the condition
of the paths between the MCU and RCU.
Please retry operation.
Logical Path between the MCU and the
RCU is not active.
The specified volume is not a M-VOL.
Recommended Action
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
Refresh the window, then retry the
operation.
If the same problem persists despite
retrying, please contact HP Technical
Support.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
If the same problem persists despite
retrying, please contact HP Technical
Support.
If the problem persists despite retrying,
please contact HP Technical Support.
If the problem persists despite retrying,
please contact HP Technical Support.
If the problem persists despite retrying,
please contact HP Technical Support.
Wait for a while, and then refresh the
window and confirm the pair status has
been changed properly.
If the pair status is not changed despite
refreshing the window, check the MCU
or RCU configuration and the condition
of the paths between the MCU and RCU.
Retry the operation.
A logical path does not exist between
the MCU and the RCU. Check the path
status on RCU Status dialog box, and
reestablish the paths with Edit Path.
Refresh the window, and check whether
the specified volume is a M-VOL.
Severity
Level
E
E
W
E
E
W
W
W
W
W
W
W
W
Part code 6005 135