Part Code 9205 - HP StorageWorks P9000 - Disk Arrays Manual

Table 82 Error codes (part code 91 10) (continued)
Part Error
Code Number
91 10 9336
91 10 56538
91 10 65648
91 10 65662
91 10 69020

Part code 9205

Table 83 Error codes (part code 9205)
Part Error
Code Number
9205 5013
9205 5030
9205 5041
9205 551 1
9205 6012
9205 6023
9205 6038
9205 6502
9205 6533
286 Message (part code group 9nnn)
Error Message
Confirm that the channel path(s) and the
device(s) included in the setting
information are set to offline, and then
select [Yes].
No volume is registered on the LDEV
group because the volume configuration
has been changed. Please delete all
LDEV groups and register LDEV groups
and Security groups again.
The specified name has already been
used by other LDKC.
The data has been changed. The settings
will be discarded if you continue the
processing. Do you want to switch the
LDKC?
If you execute this operation, the setting
will be executed forcibly.
If you apply security to volumes on which
any job is running, the job may end
abnormally.
Are you sure you want to continue this
operation?
Error Message
An error occurred during SVP
processing. If this problem persists,
please contact HP Technical Support.
No commands are issued.
The number of issued commands exceeds
the maximum.
The program product is not installed.
An error occurred during SVP
processing. If this problem persists,
please contact HP Technical Support.
An error occurred during SVP
processing. If this problem persists,
please contact HP Technical Support.
The mistake is found in the set
parameter.
Processing in progress. Please wait for
a while, and then retry the operation.
An error occurred during SVP
processing. If this problem persists,
please contact HP Technical Support.
Recommended Action
To set up, click [Yes]. Otherwise, click
[No].
Delete all LDEV groups and register LDEV
groups and Security groups again.
Specify other names.
To continue processing, click [OK].
Otherwise, click [Cancel].
To apply the settings forcibly, click [OK].
Otherwise, click [Cancel].
Recommended Action
If this problem persists, please contact
HP Technical Support.
Issue a command again.
Reduce the number of set demands.
Install the program product.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
Wait a few minutes, then retry the
operation.
If this problem persists, please contact
HP Technical Support.
Severity
Level
i
W
W
W
W
Severity
Level
E
W
W
W
E
E
E
W
E