Part Code 9010; Part Code 9105 - HP StorageWorks P9000 - Disk Arrays Manual

Part code 9010

Table 79 Error codes (part code 9010)
Part Error
Code Number
9010 7440
9010 9303
9010 65703
9010 79003

Part code 9105

Table 80 Error codes (part code 9105)
Part Error
Code Number
9105 551 1
9105 5600
9105 5601
9105 5602
9105 5603
9105 5604
9105 5605
9105 5606
9105 5607
9105 5608
9105 5609
282 Message (part code group 9nnn)
Error Message
An error occurred during processing. If
this problem persists, please contact HP
Technical Support.
There are no valid volumes.
The maximum permissible capacity of
program product became insufficient.
Please install additional license key(s) to
expand the license capacity of this
software title.
The used capacity is being calculated
now.
The licensed capacity might be
insufficient by this operation.
Error Message
The program product is not installed.
The settings of the security group are
invalid.
The settings of the host group are invalid.
The length of the letter string is invalid.
The DKC emulation is specified as the
type of the host.
The specified vendor information is
invalid.
You cannot register any more hosts.
The target LDEV is not mounted.
The settings of the LDEV group are
invalid.
The pool group cannot include volumes
to which LU paths are defined, or
volumes which are not mounted.
The R-VOL/T-VOL exists in a group which
cannot include R-VOLs and T-VOLs.
Recommended Action
If the same problem persists despite
retrying, please contact HP Technical
Support
Check the device emulation type or the
definition of the journal volume.
Install additional license key(s) to expand
the license capacity of this software title.
Purchase the license when the licensed
capacity runs short.
Recommended Action
Click [OK], then install the program
product.
Click [OK], correct the security group
settings, then retry the operation.
Click [OK], correct the host group
settings, then retry the operation.
Click [OK], correct the length of the letter
string, then retry the operation.
Click [OK], specify other hosts, and retry
the operation.
Click [OK], correct the vendor
information, and retry the operation.
Click [OK], delete unnecessary hosts,
and retry the operation.
Click [OK], delete the unmounted LDEV,
and retry the operation.
Click [OK], correct the LDEV group
settings, and retry the operation.
Click [OK], check the attributes of the
specified volumes, and retry the
operation.
Click [OK].
Change the group attribute or delete the
R-VOL/T-VOL from the group.
Retry the operation.
Severity
Level
E
W
W
i
Severity
Level
W
W
W
W
W
W
W
W
W
W
W