HP StorageWorks P9000 - Disk Arrays Manual page 247

Table 62 Error codes (part code 7105) (continued)
Part Error Error Message
Code Number
7105 8609 The specified volume is not set as a
reserved volume.
7105 8610 The T-VOL is a target volume for Auto
LUN.
7105 861 1 The specified volume is a T-VOL.
7105 8612 The specified volume is not a T-VOL.
7105 8613 The RAID level of the specified T-VOL is
not supported.
7105 8614 The command has been rejected,
because the specified T-VOL is used as
M-VOL of Continuous Access
Synchronous Z pair.
7105 8615 The command has been rejected,
because the specified T-VOL is used as
R-VOL of Continuous Access Synchronous
Z pair.
7105 8618 The T-VOL is already defined as an
S-VOL.
7105 8619 The specified T-VOL is defined as a
source volume for Auto LUN.
7105 8622 The command has been rejected,
because the specified volume is used as
M-VOL of Continuous Access
Synchronous Z pair.
7105 8623 The command has been rejected,
because the specified volume is used as
R-VOL of Continuous Access Synchronous
Z pair.
7105 8624 The command has been rejected,
because there is no pair to be operated.
7105 8625 The P-VOL(S-VOL) and S-VOL(T-VOL)
have the same number.
7105 8626 The Simplex command was rejected,
because the high-speed Split was in
progress.
7105 8627 The Pairresync operation has been
rejected, because pair status is SP-Pend.
7105 8628 An internal logic contradition occurred.
7105 8629 The status mode specification is invalid.
7105 8630 The status mode type is invalid.
Recommended Action
Check the status of the volume.
Release the Auto LUN setting.
Check the status of the volume.
Check the status of the volume.
Specify a volume of the supported RAID
level.
The requested command cannot be
executed in the current status of
Continuous Access Synchronous Z pair.
See the section "Sharing Business Copy
for Mainframe volumes" in the Business
Copy for Mainframe Systems User Guide
for the relation between the state of
Continuous Access Synchronous Z pair
and the Business Copy Z operations.
The R-VOL of Continuous Access
Synchronous Z pair cannot be used as
T-VOL of Business Copy Z.
Specify another volume.
Check the volume number.
Release the Auto LUN setting.
The P-VOL of Continuous Access
Synchronous Z pair cannot be used as
a reserved volume.
Specify another volume.
The R-VOL of Continuous Access
Synchronous Z pair cannot be used as
a reserved volume.
Specify another volume.
Confirm whether the volumes specified
for S-VOL and T-VOL are correct or not.
Check the specified volume number.
After the high-speed Split is completed,
retry the operation.
Wait until the status of the pair changes
to Split.
Select other pairs.
Check the contents, and retry.
Check the contents, and retry.
Severity
Level
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
E
W
W
Part code 7105 247