HP StorageWorks P9000 - Disk Arrays Manual page 225

Table 59 Error codes (part code 7005) (continued)
Part Error Error Message
Code Number
7005 8538 An SM failure was detected.
7005 8539 There is insufficient shared memory to
create 4096 pairs.
7005 8540 There is sufficient shared memory to
create 4096 pairs, but initial subsystem
setup is required before creating pairs.
7005 8541 There is sufficient shared memory to
create 4096 pairs, and the initial
subsystem setup is complete.
7005 8542 Failed to complete the initial shared
memory setup.
7005 8543 The shared memory size is different.
7005 8544 16 Mbytes of shared memory is
available.
7005 8545 A power supply failure is detected.
7005 8546 The command was rejected. The PS OFF
is in progress.
7005 8547 A data transfer failure is detected (CHA).
7005 8548 A data transfer failure is detected (DKA).
7005 8549 The P-VOL is not implemented.
7005 8550 The command has been rejected,
because the specified P-VOL is blocked
or used as a system disk.
7005 8551 The P-VOL is being formatted.
7005 8552 This volume cannot be specified as an
P-VOL because it is used as a command
device.
7005 8553 The S-VOL is not implemented.
7005 8554 The command has been rejected,
because the specified S-VOL is blocked
or used as a system disk.
7005 8555 The S-VOL is being formatted.
7005 8556 This volume cannot be specified as an
S-VOL because it is used as a command
device.
7005 8557 The volume is not implemented.
Recommended Action
Please contact HP Technical Support.
There is insufficient shared memory in
DKC. Please contact HP Technical
Support.
Please contact HP Technical Support.
Close the message box.
Please contact HP Technical Support.
Please contact HP Technical Support.
-
Please contact HP Technical Support.
Retry the operation with power ON.
Please contact HP Technical Support.
Please contact HP Technical Support.
You cannot execute the operation for the
volume which is not implemented.
Restore the blocked volume, then retry
the operation.
The system disk cannot be specified
as a P-VOL. Specify another volume.
Wait until the volume is formatted, and
retry the operation.
Check the target volume.
You cannot execute the operation for the
volume which is not implemented.
Restore the blocked volume, then retry
the operation.
The system disk cannot be specified
as an S-VOL. Specify another volume.
Wait until the volume is formatted, and
retry the operation.
A volume that is not used as a command
device must be specified as an S-VOL.
You cannot execute the operation for the
volume which is not implemented.
Severity
Level
E
E
E
i
E
E
i
E
W
E
E
W
E
W
W
W
W
W
W
W
Part code 7005 225