HP StorageWorks P9000 - Disk Arrays Manual page 139

Table 50 Error codes (part code 6005) (continued)
Part Error Error Message
Code Number
6005 8745 A volume cannot be used as an R-VOL
when:
it is used by Compatible XRC.
it is used by PPRC or Remote Copy.
it is used by Concurrent Copy.
it is in a reserved condition.
it is used by Continuous Access
Journal or Continuous Access Journal
Z.
it is used by Business Copy Z or
Compatible FlashCopy.
6005 8746 The device emulation type of the M-VOL
is not supported.
6005 8747 Current microcode version does not
support the specified operation.
6005 8748 Specified M-VOL may be in use by
HOST.
6005 8749 Specified R-VOL is still online from
HOST.
6005 8751 Remote Copy is not supported under the
RCU controller emulation type.
6005 8753 An internal error occurred.
6005 8754 Invalid MCU serial number or MCU
SSID.
6005 8755 The serial number, SSID or CU number
of the RCU is invalid.
6005 8756 MCU disk array cache is not active.
6005 8757 One side of the Cache or shared
memory on the MCU is blocked.
6005 8758 Unexpected error on MCU.
6005 8759 RCU Subsystem Cache status is not
active.
Recommended Action
Select another volume.
See the INSTALLATION SECTION and
OPENPLATFORM SECTION in the
maintenance manual to confirm whether
the device emulation type of the M-VOL
is supported by Remote Copy.
The version of the microcode on the
9900 storage system does not support
the specified function or operation.
Please contact HP Technical Support.
Data migration cannot start because the
volume is online. Vary the path offline,
and retry.
Check if the input number of R-VOL is
correct. If not, enter the correct R-VOL
number. If the number is correct, vary
the specified path offline.
Confirm the RCU controller emulation
type.
Please contact HP Technical Support.
Check the serial number or SSID of
MCU, then retry with correct parameter.
Check the serial number, SSID or CU
number of the RCU, and retry the
operation with correct parameters.
Check the connection LCP ports of the
RCU. Connect the path correctly, and
retry the operation
Check the storage system cache status
of the MCU from the host. If it is off, set
it on and retry. If it cannot be set on,
please contact HP Technical Support.
There is an invalid cache or shared
memory status on the MCU. Check the
status and recover the cache or shared
memory, then retry the operation.
Please contact HP Technical Support.
Please contact HP Technical Support.
Severity
Level
W
W
W
W
W
W
E
W
W
W
E
E
W
Part code 6005 139