HP StorageWorks P9000 - Disk Arrays Manual page 145

Table 50 Error codes (part code 6005) (continued)
Part Error Error Message
Code Number
6005 8843 Suspend(Pairsplit-r) operation failed
because specified volume or other
volume in the same group is not in
permissible status.
6005 8844 Suspend(Pairsplit-r) operation failed
because specified volume or other
volume in the same group is in status
transition.
6005 8845 Preset Suspension is effective in the CT
Group.
6005 8846 An internal error occurred.
6005 8847 An internal error occurred.
6005 8848 Please wait a few minutes and retry the
Suspend Pair(Pairsplit-r) operation.
6005 8849 Specified volume is not part of Remote
Copy pair (Not in Duplex(PAIR),
Pending(COPY), Suspend(PSUS) state).
6005 8850 Invalid RCU serial number, SSID, Link
Address or Controller ID.
6005 8851 The specified volume is not a R-VOL.
6005 8852 R-VOL status change failed after M-VOL
status change. Confirm R-VOL status.
6005 8854 Delete Pair(Pairsplit-S) operation failed
because M-VOL is in Simplex(SMPL)
status.
Recommended Action
The operation failed, because of one of
the following reasons:
The specified volume is simplex.
There is no duplex or duplex-pending
volume in the group.
Either the specified volume or another
volume in the same group is
suspended.
Verify the volume status, and retry the
operation.
The operation failed, because of one of
the following reasons:
The specified volume or another
volume in the same group is deleting.
The specified volume or another
volume in the same group is
suspending.
Wait for the change in status to be
completed, then retry the operation.
Cancel the preset suspension in the CT
group, then retry the operation.
Please contact HP Technical Support.
Please contact HP Technical Support.
The suspend pair (Pairsplit-r) operation
failed. A few minutes later, refresh the
window, confirm if the specified volumes
are in the permissible status, then retry
the operation.
The specified volume is not part of a
Continuous Access Synchronous pair.
Check the volume.
Check the serial number, SSID, link
address and controller ID of the RCU,
and set the correct value. Then retry the
operation. If the same error occurs,
please contact HP Technical Support.
Refresh the window, and check whether
the specified volume is a R-VOL.
Confirm the R-VOL status.
The operation failed, because of one of
the following reasons:
The specified volume is simplex.
There is no duplex, duplex-pending,
or suspend volume in the group.
Verify the volume status, and retry the
operation.
Severity
Level
W
W
i
E
E
W
W
W
W
W
W
Part code 6005 145