HP StorageWorks P9000 - Disk Arrays Manual page 249

Table 62 Error codes (part code 7105) (continued)
Part Error Error Message
Code Number
7105 8649 Because the boot device is the T-VOL in
the DeletePair command, the flag does
not match.
7105 8650 The boot device and the S-VOL do not
match in the AddPair, Resync, or
DeletePair command.
7105 8651 The SSID is invalid.
7105 8652 The boot device is not an S-VOL nor
T-VOL.
7105 8653 Because the boot device is the S-VOL in
the DeletePair command, the flag does
not match.
7105 8654 The boot device and the T-VOL do not
match in the AddPair, Resync, or
DeletePair command.
7105 8655 An invalid secondary SSID is specified
for the AddPair or Resync command.
7105 8656 An invalid secondary SSID is specified
for the Delete Pair or Split Pair
command.
7105 8657 The Swap&Freeze option cannot be
specified, because the mode 80 is on.
7105 8696 The command has been rejected,
because the specified S-VOL is being
used as the T-VOL of a Compatible
FlashCopy pair.
7105 8697 The command has been rejected,
because the specified T-VOL is being
used as the volume of a Compatible
FlashCopy pair.
7105 8698 The command has been rejected,
because the specified volume is being
used as the volume of a Compatible
FlashCopy pair.
7105 8699 The Reverse Copy or Quick Restore
command has been rejected, because
the specified S-VOL is also being used
as the volume of a Compatible
FlashCopy pair.
7105 8941 The command was rejected because the
specified CT Group is already used.
7105 8942 The CT Group operation is not available
because the target DKC microcode
version does not support the CT Group
operation.
7105 8946 A pair status cannot be changed
because the Split time of Consistency
Group is set.
Recommended Action
Check the specified volume number.
Check the specified volume number.
Check the contents, and retry.
Check the target volume number.
Check the target volume number.
Check the target volume number.
Check the contents, and retry.
Check the contents, and retry.
Please contact HP Technical Support.
Release the relationship to delete the
Compatible FlashCopy pair, or specify
another volume.
Release the relationship to delete the
Compatible FlashCopy pair, or specify
another volume.
Release the relationship to delete the
Compatible FlashCopy pair, or specify
another volume.
Release the relationship to delete the
Compatible FlashCopy pair.
Correct the specified CT Group and retry
the operation again.
Install the appropriate version of DKC
microcode.
Reset the Split time of Consistency Group
from the mainframe host.
Severity
Level
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
Part code 7105 249